Renew rooms and heating without guesswork
Open services inspected
We check accessible supplies and drainage while old fixtures are removed.
Flushing suitability tested
We assess condition and symptoms before connecting flushing equipment.
Heating planned together
We consider the boiler, radiators, controls and pipework as one system.
Remove the old bathroom and check beneath it
A full bathroom strip-out gives us access to supplies and waste that have spent years hidden behind the suite. We protect the working route, isolate services and remove the agreed toilet, basin, bath, shower and taps. For bathroom projects in Burgess Hill, we inspect visible pipework and drainage while the room is open, then prepare the connections for new fixtures. This is the right time to deal with poor routes, worn joints or unsuitable positions, before fresh finishes cover everything again. We can continue through installation and testing, giving you one planned route from the dated room to a complete new suite.


Improve heating with the right level of work
Cold radiator areas, slow warm-up and noisy circulation may point towards sludge, but we assess the system before recommending a power flush. Suitability depends on its configuration and condition, and flushing will not repair weakened parts. For broader heating changes in Burgess Hill, we can plan a central heating installation around property demand, radiator output, controls and practical pipe routes. Our experience with boilers and fault finding helps us consider the whole circuit. Where regulated gas work forms part of the installation, we hold a Gas Safe qualification through BPEC.
Frequently asked questions
Can you strip out and refit the entire bathroom?
Yes. We can isolate services, remove the old suite, inspect accessible pipework and prepare connections before fitting and testing the agreed new bathroom fixtures.
Does every cold radiator need a power flush?
No. Cold areas can also result from trapped air, valve faults or poor balance. We assess symptoms and system condition before deciding whether flushing is suitable.
Can a new heating system keep some existing parts?
Possibly. We assess current radiators, pipework, controls and the boiler before explaining which parts may remain and which changes are needed for the proposed installation.
